Lumenier Mini 4Power + Plus Pro PDB
The Lumenier Mini 4Power + Plus Pro PDB is a feature-rich power distribution board designed for mini quadcopters. The board uses a native 20x20mm mounting hole pattern as well as a 30.5x30.5mm adapter board to fit different configurations. This PDB features an easy to solder layout keeping builds clean and simple. The Mini 4Power + Plus Pro has all your power needs in one place with a selectable onboard 5v or 9v 2A BEC as well as a 184A capable current sensor.
The 4Power + Plus Pro now supports a wider range of input voltage (2-8S LiPo) giving you more freedom in your builds than ever!
Updated with the times, the 4Power + Plus Pro has an 8-pin harness for plug n' play functionality with the Lumenier F7 Ultimate Flight Controller, (and other similar flight controllers) making setup that much easier. Another new feature on the + Plus Pro is the ability to get telemetry (BLHeli_32 features) and signal from your motors to pass through to the FC via the 8 pin connector.
The voltage regulator can supply up to 2A of current, allowing them to easily power your VTX, camera, FC, and some LEDs.
- Input voltage range (2-8S operation)
- PDB: 4x30A (Max.4x46A)
- Regulated 5V (1.5A, 2A Max) and 10V (2A, 2A Max) outputs
- Current Sensor ~184A (Output Voltage Scaling is 179)
- 2oz copper, 4-layers &1.6mm PCB.
- 1x Battery input, 4x ESC outputs. 2x BEC 5V outputs, 1x BEC 8V outputs.
- Current Sensor, Gnd pads, Video Transmitter Signal & Gnd pads
- Dimensions: 30x28(+8 with XT30)x4mm, Weight: 4.5g
- Mounting holes 20mm square spacing, Φ3mm
PDB (ESC outputs)
- Continuous current: 46A max per output
BEC 5V Outputs
- Designed for RC Receivers, Flight controllers, OSD, and Servos.
- DC/DC synchronous buck regulator.
- Voltage: 5.0 +/- 0.1VDC
- Continuous current: 1.5 Amps (Max.2A 10s/minute)
- Output Ripple: 40mV (VIn=16V, [email protected] load)
- Short-circuit tolerant (5 seconds/minute)
BEC 9V Output
- Linear regulator, very low noise. LC Filter is needless.
- Designed for Video TX or FPV camera.
- Stable power output even on low voltage 3s (below 12v)
- Voltage: 8.0V +/- 0.3VDC (4~5S operation)
- Continuous current: [email protected] IN (2A Max)
- Short-circuit tolerant (2 seconds/minute)
- 1x Lumenier Mini 4Power + Plus Pro PDB
- 1x 30.5x30.5 Mounting Adapter
- 1x 8-pin to bare wire cable